FLOW Energetics Health Solutions



  • Home
  • Biofeedback
    • Biofeedback Overview
    • The Indigo Biofeedback System
    • Question & Answers
    • Biofeedback Timeline
    • Indigo Programs
    • Indigo Sound Therapy
    • Energetic Health Today
    • Peak Performance for Athletes
    • Research
  • Stress
    • Causes of Stress
    • Effects of Stress
    • Stress Reduction with Biofeedback
  • Ionic Footbath
    • The Science
  • SOQI Health Spa
    • CHI Machine
    • SOQI Bed
    • HotHouse - Infrared Heat >
      • Treat the Prostate with SOQI Hothouse
    • E-Power >
      • E-Power Wand
    • ERE
  • Service Fees
  • Contact Us
    • Newsletter

Energy Wand for E-Power

What is the Energy Wand?


The Energy Wand was developed for use with the  ePower as an alternative way to directly stimulate our body's meridians—the invisible pathways or channels for the
flow of Chi or our vital energy. Anything  that disrupts the smooth flow of “Chi” is said to cause illness.

Why the E-Power + The Energy Wand?

If we use the Energy Wand while we are on the E-Power, it will act as a conductor of the Negative Potential Energy and can then be guided along the meridians.

By evenly gliding The Energy Wand along the meridians of the arms and legs, it will remove any energy blockage in these pathways and stimulate blood flow.
(
click here for specific directions with meridian  chart)

Why Do We Need to Maintain a Good Energy Flow?

Organs carry out important functions which regulate everything from the simplest to the most complicated body functions. A good and balanced energy in the organs will promote a continuous and healthy performance of the organ.

Picture
Picture

Directions for Use:
Remove any metal accessories,  for example, jewelry, cell phones, iPod, etc. Turn the E-Power on to the Low  Mode (mode can be increased as you get experienced)
while the E-Power belt is  around your body. Simply let the cable of the Energy Wand lay on the floor without touching any part of the E-Power or its cable or any metal surface. Gently glide the Energy Wand on  the surface skin without adding any pressure.

Try to avoid using the Wand on sensitive skin areas, including your face. While gliding the Wand, make sure all 7 pins of the Wand make full contact with the skin. An electrical shock may occur if all 7 pins do not make
contact due to a significant amount of negative potential passing through those few pins that make contact.

TO CLEAN: 
Energy Wand, use an alcohol pad or a cloth/paper towel damped in soapy water, and gently rub the 7 pins.

If  the end of the wire on the Energy Wand cannot make contact with a floor or a  surface, it will still be activated and conduct negative potential energy from  the E-Power. However, it will not be as effective as being fully grounded and  making contact with a floor or surface. For this situation, it is recommended to  turn the EPA to a higher level.

Please note: the activation light may not  illuminate if the 
E-Power user operates the Energy Wand on oneself. This is  because the user is surrounded by a significant amount of negative potential  with much less positive field action to ground the Energy Wand. However, the  Energy Wand will still conduct negative potential electricity along any desired  areas where placed. The Energy Wand will be more effective if operated by someone other than the
E-Power user because of their positive field area.

Please be aware that it  may be possible for the Energy
Wand to cause small fine hairs along the arms and  legs to burn away. This is normal and considered to be a natural occurrence from  the strength of the negative potential electricity.
 It should also be noted that the Energy Wand should not stay still on the same spot for more than 3 seconds.  

Important: Although this product is safe to use and no adverse effects have been reported, we strongly  suggest that you consult with your healthcare provider before using the E-Power  and The Energy Wand.
Powered by Create your own unique website with customizable templates.